AIRTRONICS M12 Uživatelská příručka stáhnout pdf (Strana 42)



The Operating Mode of Auxiliary 1 and Auxiliary 2 can be changed to suit your specific requirements. The following Operating

Modes are available:

NOR - When Selected, the Auxiliary channel(s) operate as Normal proportional linear channels, like the Throttle or Steering

channels.

POINT - When Selected, up to six Point positions can be programmed along the entire length of servo travel. You are then

able to cycle back and forth through those Point positions. This option is ideal if your Model requires a three or more position

switch to operate a feature. This mode is not proportional. It's a 'Stepping' mode.

CODE - This option is for use with future connected products, such as an ESC, whose Programming Parameters can be

changed directly via the transmitter. For example, you might be able to change the connected ESC's Driving Modes directly

using the Auxiliary Dial to suit different conditions while you're driving.











Changing the Auxiliary Channel Operating Mode:

1) From within the SYSTEM menu, scroll UP or DOWN to highlight the AUX TYPE

menu.

2) Press the ENTER key to open the AUX TYPE menu. AUX1 > NOR will be

highlighted.

3) Scroll UP or DOWN to choose which Auxiliary Channel you want to change

the Operating Mode for, either AUX1 or AUX2.

4) Press the ENTER key, then scroll UP or DOWN to choose the desired Auxiliary 1

or Auxiliary 2 Operating Mode.

AUX1 and AUX2 setting range is NOR, POINT and CODE. The default setting for

both AUX1 and AUX2 is NOR.

Changing the Number of Points Value:

After changing the Auxiliary 1 or Auxiliary 2 Operating Mode to POINT, you are able to change the number of points you want the

servo to travel through. For example, if you want to be able to cycle your servo from 0 to 20 to 40 to 60 degrees and back again,

choose POINT > 4.

Depending on the Car Type Selected in TYPE menu, Auxiliary 2 options may not be available. This is normal.

POINT setting range is 2 to 6. The default setting is 2.

1) After choosing the POINT option, scroll UP or DOWN to the desired POINT

value, either AUX1 POINT or AUX2 POINT.

2) Press the ENTER key, then scroll UP or DOWN to choose the desired number

of Point positions to program.

When AUX1 and AUX2 values are set to NOR or CODE, POINT options cannot be programmed.

IMPORTANT: When set to POINT, please observe the following: We recommend using either the Auxiliary Dial or one of the

Trim Switches to operate the Auxiliary channel. The Auxiliary Lever is not suitable for use in this situation. In addition, the Step

value for the Auxiliary Dial and/or Trim Switch should be set to 1, otherwise the transmitter won't cycle properly through the

programmed Points.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 115 116

Žádné komentáře

AIRTRONICS M12 Uživatelská příručka Strana 42