AIRTRONICS M12 Uživatelská příručka stáhnout pdf (Strana 77)



Changing the Dual Rate Percentage Values:

1) From within the RACING menu, scroll UP or DOWN to highlight the D/R menu.

3) Scroll UP or DOWN to highlight the desired Dual Rate percentage value you

would like to change.

4) Press the ENTER key, then scroll UP or DOWN to Increase or Decrease the

Dual Rate percentage value. Increasing the percentage value will Increase

servo travel and Decreasing the percentage value will Decrease servo travel.

5) Press the ENTER key, then repeat steps 3 and 4 to change any other desired

Dual Rate percentage values.

DUAL RATE setting range is 0% to 100%. The default setting for all channels is 100%.

2) Press the ENTER key to open the D/R menu. ST > 100% will be highlighted.

Dual Rate is a percentage of End Point Adjustment. For example, if you set the Steering Dual Rate percentage value to 100%,

the Steering will travel the same amount defined by your End Point Adjustment programming. Alternately, if you set the Steering

Dual Rate percentage value to 50%, the Steering will travel half the amount defined by your End Point Adjustment programming.

























The Trim function allows you to view the current Trim value for each of the four channels and, if desired, allows you to change the

Trim values using the Push-Button Rotary Dial from within the TRIM menu. For example, if you don't Assign Auxiliary 1 Trim to a

Trim Switch, you can still Trim the Auxiliary 1 channel from within the TRIM menu.

The M12 features Digital Trim Memory. Any amount of Trim that you set during use using the Trim Switches or through the TRIM

menu is automatically stored in memory for that specific channel and for that specific Model. The Trim values for each Model will

automatically be loaded when the transmitter is turned ON.

Each time you move a Trim Switch a short audible Tone is heard. When the Trim value reaches 0 (Centered), a longer audible

Tone sounds. This indicates to you that the Trim is centered without the need to look at the transmitter.

In the default configuration, Trim Switch Trm1 and Trm2 move the Steering and Throttle/Brake Trim in 5% increments. If

you want to Increase or Decrease the Trim Resolution, see the

Changing the Trim Switch Step Value

section on page 35.

In the default configuration, Trim Switch Trm1 controls Steering Trim and

Trim Switch Trm2 controls Throttle/Brake Trim. Auxiliary channel Trim can be

changed while you're driving by Assigning the Trim function to another Trim

Switch or the Auxiliary Dial. For more information, see the

ASSIGN Menu

section on pages 33 ~ 38.

The current Trim positions for all four channels is

shown on the Trim Displays on the STATUS screen.

PRO TIP: The Trim function features two different Trim Type options that you can choose from. Choose from either Center Trim

or Parallel Trim. For more information, see the

TRIM TYPE Menu

section on page 43.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 115 116

Komentáře k této Příručce

Žádné komentáře

AIRTRONICS M12 Uživatelská příručka Strana 77

Komentáře k této Příručce

Související produkty a manuály pro Dálková ovládání AIRTRONICS M12