AIRTRONICS M12 Uživatelská příručka stáhnout pdf (Strana 90)













#ST

#L-ST

#F/ST

#TH

#F/TH

AUX1

BR2

#AUX1

#BR

#BR2

#R-ST

#R/ST

#R/TH

AUX2

#AUX2

Steering

# Steering

# Left Steering

# Front Steering

Throttle

# Throttle

# Front Throttle

Auxiliary 1

Brake

Brake 2

# Auxiliary 1

# Brake

# Brake 2

# Right Steering

# Rear Steering

# Rear Throttle

Auxiliary 2

# Auxiliary 2

Raw Output Data, Plus CURVE and SPEED

Raw Output Data, Plus TRIM, EPA, D/R, CURVE and SPEED

Raw Output Data, Plus CURVE, SPEED and BR-MIX

Raw Output Data, Plus TRIM, EPA, D/R, CURVE, SPEED, ALB, OFFSET, BR-MIX and TH-HOLD

Raw Output Data, Plus CURVE and SPEED (Referred to as AUX in some Car Types)

Raw Output Data, Plus CURVE, SPEED and BR-MIX

Raw Output Data, Plus TRIM, EPA, D/R, CURVE and SPEED

Raw Output Data, Plus TRIM, EPA, D/R, CURVE, SPEED, ALB, OFFSET, BR-MIX and TH-HOLD

Raw Output Data, Plus TRIM, EPA, D/R, CURVE and SPEED

Raw Output Data, Plus TRIM, EPA, D/R, CURVE, SPEED, ALB, OFFSET, BR-MIX and TH-HOLD

Raw Output Data, Plus CURVE and SPEED

Raw Output Data, Plus TRIM, EPA, D/R, CURVE and SPEED

CH. NAME

CH. CH. OUTPUT DATA

The table below shows the Channel Output Data of each Master channel. This is the Data that will be duplicated on the Slave

channel when Compensation Mixing is turned ON. Master channels denoted with a Pound sign (#) indicate that not only is the

Raw Output Data duplicated on the Slave channel, but the other functions described are also duplicated on the Slave channel.

For example, if MASTER > #ST is Selected, any Master channel Steering Trim, End Point Adjustments, Dual Rate, Curve and Speed

values, plus the Raw Output Data will be duplicated on the Slave channel. Alternately, if you Select MASTER > ST, only Curve and

Speed values, plus the Raw Output Data will be duplicated on the Slave channel.

Changing the Master Channel:

1) From within the RACING menu, scroll UP or DOWN to highlight either the

C-MIX1 or the C-MIX2 menu depending on which Compensation Mixer you

want to program. In this section, we show programming Compensation Mixer 1.

2) Press the ENTER key to open the C-MIX1 menu. MASTER > ST will be highlighted.

3) Press the ENTER key, then scroll UP or DOWN to choose the desired Master

channel.

Changing the Slave Channel:

1) From within the C-MIX1 menu, scroll UP or DOWN to highlight S

LAVE > TH.

2) Press the ENTER key, then scroll UP or DOWN to choose the desired Slave

channel.

Channels denoted with a Pound (#) sign cannot be chosen as Slaved

channels.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 115 116

Komentáře k této Příručce

Žádné komentáře

AIRTRONICS M12 Uživatelská příručka Strana 90

Komentáře k této Příručce

Související produkty a manuály pro Dálková ovládání AIRTRONICS M12