AIRTRONICS M12 Uživatelská příručka stáhnout pdf (Strana 62)













The End Point Adjustment function allows you to adjust servo travel in each direction. This makes it possible to balance servo

travel in both directions and set the maximum desired amount of servo travel. For example, on a gas-powered Model, if you pull

the Throttle Trigger and the carburetor does not open completely, you can Increase the Throttle High End Point Adjustment so

that the carburetor opens completely. Another example is with Steering. If your Model turns sharper to the Right than to the Left,

you can Increase the Steering Left End Point Adjustment to balance the Steering.

The End Point Adjustment function can be adjusted for the Steering channel (Right and Left), the Throttle channel (High and

Brake), the Auxiliary 1 channel (High and Low) and the Auxiliary 2 channel (High and Low).

Before making End Point Adjustments, the servo horn needs to be centered. Install the servo horn onto the servo, making

sure it's as close to being centered as possible, then use the Servo Sub-Trim function to center the servo arm exactly. For

more information, see the

SUB TRIM Menu

section on page 63.

Changing the Channel End Point Adjustment Percentage Values:

1) From within the SETUP menu, scroll UP or DOWN to highlight the EPA menu.

2) Press the ENTER key to open the EPA menu. The cursor will default to either

ST > L100% or ST > R100%.

3) Scroll UP or DOWN to highlight the desired End Point Adjustment percentage

value you would like to change.

4) Press the ENTER key, then scroll UP or DOWN to Increase or Decrease the

End Point Adjustment percentage value. Increasing the percentage value will

Increase servo travel in that direction and Decreasing the percentage value

will Decrease servo travel in the that direction.

If you're using an Electronic Speed Control, the Throttle High and the Throttle Brake End Point Adjustment percentage

values are both generally set to 100%, although the Throttle High direction may need to be increased to achieve full power.

In some cases, Throttle and Brake End Point Adjustments can also be set directly via the Electronic Speed Control.

5) Press the ENTER key, then repeat steps 3 and 4 to change any other desired

End Point Adjustment percentage values.

ST L and R setting range is 0% to 150%, TH H and B setting range is 0% to 150%, AUX1 H and L setting range is 0% to 150%

and AUX2 H and L setting range is 0% to 150%. The default setting for all channels is 100%.

End Point Adjustment percentage values should not be increased to the point where your

linkages and servos Bind when moved all the way to the Right or Left. Binding will cause

the servos to 'buzz', resulting in a quicker loss of receiver battery power and eventual damage to

the servos or to your Model.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 115 116

Žádné komentáře

AIRTRONICS M12 Uživatelská příručka Strana 62